WEBEREND AID Equalises Suction on Mixed Backgrounds 25KG

<div id="c5823" class="box"> <h3 class="csc-firstHeader">ABOUT THIS PRODUCT</h3> Preparatory key coat for rendering <ul> <li>Ideal as a pre-treatment for renderings required to resist severe exposure conditions</li> <li>Suitable substrates: dense concrete brickwork blockwork masonry clean, sound, well adhered existing render (<19mm)</li> </ul> </div> <div id="c5824" class="box"> <h3 class="csc-firstHeader">FEATURES AND BENEFITS</h3> <ul> <li>Equalises suction on mixed backgrounds</li> <li>Resists the penetration of external water to improve the weather resistance of rendering systems</li> <li>Quality controlled and factory blended to give a consistently high quality product</li> <li>Easy to apply by hawk and trowel and/or roller</li> </ul> <div id="c5827" class="box"> <h3 class="csc-firstHeader">MIXING</h3> Mix three parts of <strong>weberend aid</strong> with one part of clean water in a clean container, using a suitable drill with whisk attachment. For smaller quantities a hand whisk may be used. After mixing, leave to stand for approximately 5 minutes before remixing to a workable consistency, adding more water if necessary. </div> <div id="c5828" class="box"> <h3 class="csc-firstHeader">APPLICATION</h3> With a hawk and trowel or an open hopper spray gun, apply a tight layer 2 - 3 mm thick to the substrate. Texture the surface using a well loaded roller. Apply no more than 2 - 3 m2 before texturing. <strong>It is important that the final texture achieved should be a deep, heavy stipple finish with a textured depth of 5 - 10 mm.</strong> For difficult substrates, such as those with low suction or those retaining dust after cleaning, scrub <strong>weberend aid</strong>well into the surface with a small hand brush and then texture with the brush or roller. <strong>Cure for 2-3 days before over coating.</strong> During rapid drying conditions such as hot climates, curing with a fine spray of clean water may be necessary. <strong>Protection</strong> Protect from unfavourable weather conditions during application and early curing. <strong>Good practice</strong> Do not apply: <ul> <li>If frost is forecast within 24 hours of use</li> <li>In damp/wet conditions</li> <li>In temperatures below 5°C or above 30°C</li> <li>On elevations in direct sunlight or where the substrate is hot</li> </ul> </div> <div id="c5829" class="box"> <h3 class="csc-firstHeader">CLEANING</h3> Keep equipment clean by washing frequently during application and wash immediately after use with clean water. Do not dispose of waste material into drainage systems. </div> </div>